A Flashing Fault Lamp
Part of the Timers section of Coddy's PLC Programming journey. Lesson 10 of 18.
A flashing lamp catches the eye better than a steady one, so fault lamps usually flash.
Many programs keep one flasher running all the time, from power-on, and use its T1.Q wherever something should blink. A lamp that should flash gets a contact on the flasher in series with its own condition.
Rung 1 has no switch in front: the flasher never stops. Rung 3 lets it through to the lamp only while the overload is tripped.
Challenge
EasyThe fault lamp is steady. Make FaultLamp flash, 0.5 s on and 0.5 s off, while the overload is tripped. Keep the motor and the run lamp as they are.
Try it yourself
{"v":1,"lang":"ld","tags":[],"rungs":[{"els":[{"t":"par","branches":[[{"t":"no","tag":"Start"}],[{"t":"no","tag":"Motor"}]]},{"t":"no","tag":"Stop"},{"t":"no","tag":"Overload"},{"t":"coil","tag":"Motor"}]},{"els":[{"t":"no","tag":"Motor"},{"t":"coil","tag":"RunLamp"}]},{"els":[{"t":"nc","tag":"Overload"},{"t":"coil","tag":"FaultLamp"}]}]}All lessons in Timers
4Project: Pedestrian Crossing
Green Until PressedAmber Before RedRed and WalkClear the CrossingThe Wait LampNight ModePractice on your own: PLC playground