Night Mode
Part of the Timers section of Coddy's PLC Programming journey. Lesson 18 of 18.
At night, with little traffic, many crossings switch off the cycle. The car signal flashes amber, which means "go with care", and every other lamp is dark.
Add a flasher that runs only while Night is on. A flasher that always runs, like the fault lamp's, works too, with Night in series with its output. Then give every lamp rung a normally closed Night, and let the flasher light Amber on a second path:
A press at night should do nothing, so Night also stops the button from setting Req, and resets it.
Challenge
Hard- with
Nighton,Amberflashes 0.5 s on, 0.5 s off - every other lamp is dark, and WalkButton does nothing
- with Night off, the crossing works as before
Try it yourself
{"v":1,"lang":"ld","tags":[{"name":"Req","type":"BOOL"},{"name":"T1","type":"TON"},{"name":"T2","type":"TON"},{"name":"T3","type":"TON"}],"rungs":[{"els":[{"t":"no","tag":"WalkButton"},{"t":"set","tag":"Req"}]},{"els":[{"t":"no","tag":"Req"},{"t":"TON","inst":"T1","pt":"T#3s"}]},{"els":[{"t":"no","tag":"T1.Q"},{"t":"TON","inst":"T2","pt":"T#5s"}]},{"els":[{"t":"no","tag":"T2.Q"},{"t":"TON","inst":"T3","pt":"T#2s"}]},{"els":[{"t":"nc","tag":"Req"},{"t":"coil","tag":"Green"}]},{"els":[{"t":"no","tag":"Req"},{"t":"nc","tag":"T1.Q"},{"t":"coil","tag":"Amber"}]},{"els":[{"t":"no","tag":"T1.Q"},{"t":"coil","tag":"Red"}]},{"els":[{"t":"no","tag":"T1.Q"},{"t":"nc","tag":"T2.Q"},{"t":"coil","tag":"Walk"}]},{"els":[{"t":"nc","tag":"Walk"},{"t":"coil","tag":"DontWalk"}]},{"els":[{"t":"no","tag":"Req"},{"t":"nc","tag":"T1.Q"},{"t":"coil","tag":"Wait"}]},{"els":[{"t":"no","tag":"T3.Q"},{"t":"reset","tag":"Req"}]}]}This lesson includes a short quiz. Start the lesson to answer it and track your progress.
All lessons in Timers
4Project: Pedestrian Crossing
Green Until PressedAmber Before RedRed and WalkClear the CrossingThe Wait LampNight ModePractice on your own: PLC playground