Meet the Motor
Part of the First Rungs section of Coddy's PLC Programming journey. Lesson 11 of 20.
This is a motor station: a three-phase motor, its contactor, and a panel with Start and Stop buttons.
The PLC never powers the motor itself. Its output Motor switches the contactor's coil, and the contactor closes three heavy contacts that carry the motor's current. Watch it on the drawing: when the output turns on, the contacts close and the motor spins up.
Challenge
EasyRun the motor while Start is held.
Press Run, hold Start, watch the motor, then Check.
Try it yourself
{"v":1,"lang":"ld","tags":[],"rungs":[{"els":[]}]}All lessons in First Rungs
3The Motor Station
Meet the MotorWhy Stop Is Wired NCThe Seal-InThe Overload RelayThe Run LampThe Fault LampPractice on your own: PLC playground