Menu
CoddyTech

The Overload Relay

Part of the First Rungs section of Coddy's PLC Programming journey. Lesson 14 of 20.

A motor that jams draws too much current and overheats. The overload relay measures the current and trips when it is too high for too long. Like Stop, its contact is wired normally closed: Overload reads TRUE while all is well.

Add it in series and a trip stops the motor. Because it also breaks the seal-in, the motor does not start again on its own when the relay is reset: someone has to press Start.

The relay's own contact also cuts the contactor, so the drawing stops the motor on a trip even without this contact. Without it, though, the seal-in holds and the motor starts again the moment the relay is reset.

challenge icon

Challenge

Easy

Add Overload to the motor rung. Run the motor, switch the overload to Trip, then back to OK: the motor must stay stopped until Start.

Try it yourself

{"v":1,"lang":"ld","tags":[],"rungs":[{"els":[{"t":"par","branches":[[{"t":"no","tag":"Start"}],[{"t":"no","tag":"Motor"}]]},{"t":"no","tag":"Stop"},{"t":"coil","tag":"Motor"}]}]}

All lessons in First Rungs

Practice on your own: PLC playground