Project: Motor Panel
Part of the First Rungs section of Coddy's PLC Programming journey. Lesson 20 of 20.
Build a whole motor station from an empty program, as on a real panel:
- Start runs the motor and it keeps running
- Stop stops it
- a tripped overload stops it, and it waits for Start after the reset
- the run lamp and the fault lamp say what is going on
Remember which inputs are wired NC. Write one coil per output.
Challenge
MediumBuild the motor station: the seal-in with Stop and the overload, RunLamp while it runs, FaultLamp while the overload is tripped.
Try it yourself
{"v":1,"lang":"ld","tags":[],"rungs":[{"els":[]}]}This lesson includes a short quiz. Start the lesson to answer it and track your progress.
All lessons in First Rungs
Practice on your own: PLC playground