Why Stop Is Wired NC
Part of the First Rungs section of Coddy's PLC Programming journey. Lesson 12 of 20.
The Stop button is wired normally closed: its circuit is closed until you press it. So the input reads TRUE at rest and FALSE while pressed. Open the I/O table: Stop says wired NC.
Why? If a wire breaks, the input reads FALSE, exactly like a press, and the machine stops. A stop that fails safe. Wired normally open, a broken wire would make Stop do nothing.
In the program that means a normally open contact on Stop: it passes power while the input is TRUE, while nobody presses Stop.
Challenge
EasyRun the motor while Start is held, but never while Stop is pressed.
Try it yourself
{"v":1,"lang":"ld","tags":[],"rungs":[{"els":[{"t":"no","tag":"Start"},{"t":"coil","tag":"Motor"}]}]}All lessons in First Rungs
3The Motor Station
Meet the MotorWhy Stop Is Wired NCThe Seal-InThe Overload RelayThe Run LampThe Fault LampPractice on your own: PLC playground